Guide :Toys : Vespa Scooter

Routing cables I am now in the process of doing a ground-up re-assembly of a '79 P200E and despite having taken pictures and labelled parts properly, I find myself at a loss regarding the routing of new rear cables, specifically which frame holes the two gear cables, clutch cable, throttle cable and rear brake cable go through. There is a circular hole inside the rear fender front at the bottom - right hand side. I have the wiring to the rear brake/taillight coming out of that. I have also routed the two gear cables, clutch cable and rear brake cable through that hole. Is that correct? Then behind the right hand side cover there are two small holes below the large air intake hole. I have routed the throttle cable through the higher of these two holes (circular). Is that correct? I have nothing routed through the lower hole (oblong) so I must have done something wrong. I have looked through my Haynes workshop manual but there are no pictures showing exactly how the cables enter the frame from the back. Any help you can provide would be appreciated. Thanks Nick Pratt

Posted by npratt on Mar 03, 2017

Research, Knowledge and Information :



We did not find results for: routing cables i am now in the process of doing a ground up re assembly of a 79 p200e and despite having taken pictures and labelled parts properly i find myself at a loss regarding the routing of new rear cables specifically which frame holes the two gear cables clutch cable throttle cable and rear brake cable go through there is a circular hole inside the rear fender front at the bottom right hand side i have the wiring to the rear brake taillight coming out of that i have also routed the two gear cables clutch cable and rear brake cable through that hole is that correct then behind the right hand side cover there are two small holes below the large air intake hole i have routed the throttle cable through the higher of these two holes circular is that correct i have nothing routed through the lower hole oblong so i must have done something wrong i have looked through my haynes workshop manual but there are no pictures showing exactly how the cables enter the frame from the back any help you can provide would be appreciated thanks nick pratt.

Loading ...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.jefferson-airplane.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0079 seconds